ABSTRACT It is a well-known fact that the application of pesticides can be improved using an electrostatic spray due to the reduction of the application rate and increase in deposition on plant targets. However, little information exists on the use of such technology in maize crops. Thus, this study is aimed to evaluate the spray deposition on maize resulting from spray application using an electrostatic sprayer in combination with low application rates and different spray compositions. A field experiment was conducted in a randomized block having a 2×2×2 factorial design with two application rates (95 and 52 L ha-1), with or without the spray electrification, and with or without the synthetic adjuvant. The droplet electrification ability, interference of the electrical conductivity of the spray solution, losses of spray solution to the soil, and spray deposition on maize plants were evaluated for two cases of insecticide applications. The Faraday cage method was used to determine the spray electrification ability of the equipment. The spray deposition on plants and the losses to the soil were analyzed using a tracer (food coloring dye) added to the spray solution that was subsequently detected by spectrophotometry. It was seen that the electrostatic sprayer improved the spray application efficiency, which responded positively to the increase in the electrical conductivity of the spray solution. The deposition of the electrified spray solution on the upper third canopy of maize was found to be higher; the spray solution electrification also reduced the losses to the soil, regardless of the application rate.

ABSTRACT Electrostatic spray can bring benefits to the pesticide application such as the reduction of application rate and the increase of deposits on targets. Therefore, this study aimed to evaluate the effect of electrostatic spraying using lower application rates and different adjuvants on soybean spray deposition and chemical control of powdery mildew (Microsphaera diffusa Cooke & Peck). The field experiment was conducted in duplicate. A randomized complete block design with four replications in a 2 × 2 × 2 + 1 factorial scheme was used. The factors were two application rates, with and without droplet electrification, two spray solution compositions, and one additional treatment. Deposition on upper and lower leaves, spray loss to the soil, and powdery mildew control effectiveness were evaluated. The electrical conductivity of the spray solution and the charge/mass ratio induced in droplets were also evaluated. All treatments reduced the soybean powdery mildew severity. Electrostatic spraying responded positively to an increase in the electrical conductivity of the spray solution regarding the charge/mass ratio, but it did not increase spray deposition on the lower third of the canopy and did not influence spray loss to the soil, which was higher as the application rate increased.

ABSTRACT Adjuvants are tools to maximize pesticide spray quality. This study aimed to evaluate the interaction effects between adjuvants and the fungicide azoxystrobin + benzovindiflupyr on the physicochemical characteristics, droplet evaporation time, and spray droplet size. The experiment was carried out using a 2×6 factorial scheme, in which the first factor was the absence or presence of the fungicide mixture (water or water + fungicide) and the second factor was the presence of different adjuvants (water and five adjuvants). The parameters evaluated were surface tension, pH, viscosity, electrical conductivity, droplet evaporation time, volume median diameter, percentage of droplets smaller than 100 μm, and relative amplitude of the droplet spectrum. The silicone and propionic acid + soy lecithin adjuvants reduced the pH of the spray solution, and the sodium lauryl ether sulfate, propionic acid + soy lecithin, and orange essential oil adjuvants reduced droplet evaporation when mixed with the fungicide. All tested adjuvants improved spray quality related to the characteristics of the droplet spectrum, reducing the percentage of droplets smaller than 100 μm, and allowing more uniform droplet size. The fungicide azoxystrobin + benzovindiflupyr affected droplet evaporation time.

ABSTRACT The use of insecticides is common in pest management in wheat crops but may lead to higher production costs and environmental contamination. Therefore, a more comprehensive and uniform distribution of plant protection products in the desired target is recommended. The objective of this study is to evaluate the effect of different spray nozzles, application rates, and adjuvants on droplet spectrum and spray deposition in wheat crops. The physicochemical characteristics of the spray mixture, droplet spectrum, and spray deposition in wheat plants were evaluated. The lower application rate (75 L ha−1) combined with the use of the twin flat fan tip AS7030 and the adjuvant sodium lauryl ether sulfate (SLES) yielded droplets with a larger diameter. However, insecticide spraying using hollow cone tip MGA 015 without adjuvants provided the highest percentage of droplets susceptible to drift. SLES significantly decreased the percentage of drift by increasing droplet size, and the adjuvant silicone, d-limonene, and polyester copolymer increased spray deposition. The evaluated adjuvants increased the electrical conductivity and reduced the surface tension of the spray mixtures. These results indicate that it is possible to reduce the application rate from 150 to 75 L ha−1 without affecting spray deposition on wheat leaves.